Standby State-Up - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference — V1.00
logic channel acts as the main interface, it will be switched to the standby interface. If
the logic channel acts as the standby interface, it will be switched to a standby
interface with lower priority.
If the logic channel serves as a main interface, this command can be executed
normally only after the standby interface or standby logic-channel command has
been used to specify physical interfaces or logic channel. If the logic channel serves
as a standby interface, it can be executed normally only after the standby
logic-channel command is used to specify the logic channel to backup the main
interface.
For related commands, see standby state-up.
Example
# Set the number of calls when the logic channel is judged to be down to 4.
[3Com-logic-channel1]standby state-down 4

1.1.6 standby state-up

Syntax
standby state-up seconds
undo standby state-up
View
Logic channel view
Parameter
seconds: Status check interval in second, ranging from 0 to 65535, being 1 by default.
Description
Using the standby state-up command, you can configure the status check interval
used to judge whether the logic channel is restored to up. Using the undo standby
state-up command, you can cancel the existing setting.
If a logic channel is down, the system will judge whether the state of logic channel has
been restored to up every status check interval (specified by seconds), so that this
logic channel can be switched back as soon as it is restored to up.
If the logic channel serves as a main interface, this command can be executed
normally only after the standby interface or standby logic-channel command has
been used to specify physical interfaces or logic channel. If the logic channel serves
6