Filter-Policy Import - 3Com 3C13618 Command Reference Manual

3com 3c13618: reference guide
Table of Contents

Advertisement

Example
# Display virtual links information related to OSPF.
[3Com]display ospf vlink
Virtual Interfaces:
Vlink peer-id 3.3.3.3
Interface: 16.1.1.2 (Ethernet0)
Cost: 10 State: P To P
Transit Area: 0.0.0.1
Configure as demand circuit
Run as demand circuit
DoNotAge lsa allowed
Authentication: none
Timers: Hello: 10 Poll: 0 Dead: 40 Retrans: 5 Transmit Delay: 1
In the above information, Transit Area is the transit area through the virtual connection
passes. The area cannot be the backbone area, nor STUB area, nor NSSA area.

3.1.19 filter-policy import

Syntax
filter-policy acl-number import
undo filter-policy acl-number import
View
OSPF view
Parameter
acl-number: Serial number of the ACL.
For detailed description, refer to the filter-policy import command in chapter 5 "IP
Routing Policy Configuration Commands".
Description
Using the filter-policy import command, you can configure filtering for received
routing information and filtering policy. Using the undo filter-policy import command,
you can cancel routing information filtering policy.
By default, disable filtering.
When an Autonomous System (AS) runs the OSPF routing protocol, each router of it
can have the knowledge about the routes of all the other routers within the AS. In real
Type: Virtual
Routing Protocol
51

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

3c136123c136133c13616

Table of Contents