as a standby interface, it can be executed normally only after the standby
logic-channel command is used to specify the logic channel to backup the main
interface.
For related commands, see standby state-down.
Example
# Set the status check interval used to judge whether the state has been restored to
up to 10 seconds.
[3Com-logic-channel1]standby state-up 10
1.1.7 standby threshold
Syntax
standby threshold enable-threshold disable-threshold
undo standby threshold
View
Interface view
Logic channel view
Parameter
enable-threshold: The upper limit percentage of enabling standby interfaces and logic
channels. This value ranges from 0 to 99.
disable-threshold: The lower limit percentage of disabling standby interfaces and logic
channels. This value ranges from 0 to 99.
Description
Using the standby threshold command, you can configure the standby load
balancing for an interface or a logic channel. Using the undo standby threshold
command, you can cancel the standby load balancing of an interface or a logic
channel.
By default, no standby load balancing is configured.
This command should be configured on the main interface of the standby center.
When the traffic on all the active interfaces of the standby center reaches the set
upper limit, the available standby interface with the highest priority will be enabled.
Reliability
7