X25 Map - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
Description
Using the x25 ignore calling-address command, you can omit the X.121 address of
the calling DTE in outgoing calls while X.25 originates the call. Using the undo x25
ignore calling-address command, you can disable the function.
By default, this function is disabled.
According to X.25, the call request packet must carry the address code group. But in
some occasions, the X.25 call request does not have to carry the called/calling DTE
address in a specific network environment or as is required by the application. This
command enables you to specify whether the call request sent by X.25 in the 3Com
series routers carries the calling DTE address.
For related commands, see x25 response called-address, x25 response
calling-address x25, suppress-called-address.
Example
# No calling DTE address in outgoing x25 calls originated from interface Serial0.
[3Com-Serial0]x25 ignore calling-address

5.1.28 x25 map

Syntax
x25 map { ip | ipx } protocol-address x121-address x.121-address [ option ]
undo x25 map { ip | ipx } protocol-address
View
Interface view
Parameter
ip: Use IP protocol.
ipx: Use IPX protocol.
protocol-address: network protocol address of the remote device.
x.121-address: X.121 address of the remote device.
option: additional feature or user facility (optional)
Description
Using the x25 map command, you can configure up the LAN protocols-to-X.121
address mapping. Using the undo x25 map command, you can cancel the specify
mapping.
By default, no mapping is set up.
64