Display Ft1 Serial; Ft1 Clock - 3Com 3C13618 Command Reference Manual

3.5.2 display ft1 serial

Syntax
display ft1 [ serial serial-number ]
View
All views
Parameter
serial serial-number: Interface type and number. If no interface is specified, the
information of all the T1-F interfaces will be displayed.
Description
Using the display ft1 serial command, you can view the configuration and state of
T1-F interface.
If the specified interface is a serial interface rather than a T1-F interface, the system
will display the error prompt "The serial is not a factional interface".
Example
# Display the information of the T1-F interface.
[3Com]display ft1 serial 0
Serial1
Module type is T1/fractional, T1-F is down.
Applique type is framed - 100 OHM balanced.
Framing is ESF, Line Code is B8ZS, Source Clock is Slave.
Alarm State is Loss-of-Signal.

3.5.3 ft1 clock

Syntax
ft1 clock { master | slave }
undo ft1 clock
View
T1-F interface view
Interface Management
55