Interface Bridge-Template - 3Com 3C13618 Command Reference Manual

3com 3c13618: reference guide
Table of Contents

Advertisement

Description
Using the display bridge traffic command, you can view the statistics of bridge set
traffic on the interface.
Example
# Display the statistics of bridge set traffic on port Ethernet0.
[3Com]display bridge traffic
Port No: 2 (Ethernet0)
Port in frames: 0
Port out frames: 0
Port in discards: 0
Port out discards: 0
Mtu exceeded discards: 0
Learned entry discards: 0

8.1.33 interface bridge-template

Syntax
interface bridge-template bridge-set
undo interface bridge-template bridge-set
View
System view
Parameter
bridge-set: The bridge set number corresponding to the bridge-template interface. It is
in the range of 1 to 63.
Description
Using the interface bridge-template command, you can create a bridge-template
interface for connecting the interfaces of specified bridge set to the other routed
interfaces in the routing network. Using the undo interface bridge-template command,
you can cancel bridge-template interface.
By default, no bridge-template interface is created.
The corresponding bridge-template interface must be created and the corresponding
network-layer attributes must be configured if IP or IP X packets are expected to be
bridged or routed in a bridge set. However, you cannot configure any bridge attribute on
the bridge-template interface.
Example
# Configure a bridge-template interface and enters the bridge-template interface view.
Link Layer Protocol
165

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

3c136123c136133c13616

Table of Contents