Firewall Default; Firewall Packet-Filter - 3Com 3C13618 Command Reference Manual

3.1.8 firewall default

Syntax
firewall default { permit | deny }
View
System view
Parameter
permit: Default filter attribute is "permit".
deny: Default filter attribute is "deny".
Description
Using the firewall default command, you can configure the default filter mode when
there is no matching access rule.
By default, Packets are permitted to pass the firewall in the case that the firewall is
enabled.
If none of the access rules applied at the interface can judge if a packet is permitted
or denied, the default filter attribute will function. If the default filter attribute is
"Permitted", then the packet can pass, otherwise it will be dropped.
Example
# Configure the default filter attribute to "Permitted".
[3Com]firewall default permit

3.1.9 firewall packet-filter

Syntax
firewall packet-filter { acl-number } { inbound | outbound }
undo firewall packet-filter { acl-number } { inbound | outbound }
View
Interface view
Security
35