3Com Router Command Reference — V1.00
When the total traffic on all the active interfaces of the standby center is lower than
the set lower limit, the standby interface with the lowest priority will be disabled.
The enable-threshold must not be less than disable-threshold.
When undo standby threshold is being applied, if the existing standby interfaces are
enabled, the command will shut down all the standby interfaces, and only the main
interface works.
For related commands, see standby interface, standby logic-channel.
Example
# Configure standby load balancing on interface Serial 0.
[3Com-Serial0]standby threshold 80 50
1.1.8 standby timer disable-delay
Syntax
standby timer disable-delay seconds
undo standby timer disable-delay
View
Interface view
Logic channel view
Parameter
seconds: The delay interval for the standby interface to switch to the main interface. It
ranges from 0 to 65535 seconds. By default, it is 0 second.
Description
Using the standby timer disable-delay command, you can configure the delay
interval for the standby interface to switch to the main interface. Using the undo
standby timer disable-delay command, you can restore the default value of the
delay interval for the standby interface to switch to the main interface.
It is recommended to set the switching delay to prevent frequent main/standby
interface switching due to the instability of the interface status. If the delay interval for
the switch between the main interface and the standby interface is 0, the switch will
be performed at once when the interface status changes.
For related commands, see standby timer enable-delay.
8