Nat Reset; Nat Server - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
data message that conforms to the address access control list by configuring the
correlation between the address control list and the interface. To translate by
selecting one address in the address pool or by using the IP address of the interface
directly, you can configure different address translation correlation on one interface.
Example
# The host computers of the 10.110.10.0/24 network segment are allowed for
address translation, selecting the addresses from 202.110.10.10 to 202.110.10.12 as
the translated address. Assume that ISP is connected by Serial0 port.
[Quidway]acl 1
[Quidway-acl-1]rule permit source 10.110.10.0 0.0.0.255
# Add correlation between the address list and the address pool.
[Quidway-Serial0] nat outbound 1 interface

2.6.8 nat reset

Syntax
nat reset
View
Interface view
Parameter
None
Description
Using the nat reset command, you can reset NAT mapping table.
Example
None

2.6.9 nat server

Syntax
nat server global global-addr { global-port | any | domain | ftp | pop2 | pop3 | smtp
| telnet | www } inside inside-addr { inside-port | any | domain | ftp | pop2 | pop3 |
smtp | telnet | www } { protocol-number | ip | icmp | tcp | udp }
46