X25 X121-Address - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
Example
# Set the incoming and outgoing window sizes on the X.25 interface Serial0 to 6.
[3Com-Serial0]x25 window-size 6 6

5.1.53 x25 x121-address

Syntax
x25 x121-address x.121-address
undo x25 x121-address
View
Interface view
Parameter
x.121-address: X.121 address of an interface, in the format of numerical character
string of 1 to 15 bits.
Description
Using the x25 x121-address command, you can configure the X.121 address of an
X.25 interface. Using the undo x25 x121-address command, you can cancel the
address.
If a router is connected to an X.25 public data network, then the ISP shall assign a legal
X.121 address for it. In a setting where two routers are connected back to back, this
legal X.121 address can be specified at your discretion. If you want the router to work in
a switched mode, you do not have to configure the X.121 address.
Note: For the format of the X.121 address and the dynamic conversion of IP address
and X.121 address, please consult ITU-T Recommendation X.121 and relevant RFC
documents.
For related commands, see display interfaces.
Example
# Configure X.25 protocol on interface Serial0 and sets the X.121 address as
20112451.
[3Com]channel interface serial 0
[3Com-Serial0]link-protocol x25
[3Com-Serial0]x25 x121-address 20112451
88