Timerange - 3Com 3C13618 Command Reference Manual

3Com Command Reference Guide — V1.00
Description
Using the settr command, you can configure a special time range. Using the undo
settr command, you can cancel the set special time range.
By default, no settr is configured, that is, all are set to normal time ranges.
This command is used to configure the time range. Six time ranges can be
configured at most at the same time, and they can be displayed via the display
timerange command. If a time range being used is to be modified, this modification
will be take effect in a minute (the system queries the time interval for the time range).
The time range should be set in the 24-hour system. If you want to set a time range
from 9pm to 8am, you can set it to "settr 21:00 23:59 0:00 8:00". Because both ends
of the set time range belong to the same time range, no switching will take place
within the time range. In addition, this setting has withstood the Y2K test.
For related commands, see timerange, display timerange.
Example
# Configure the time range as 8:30 - 12:00, 14:00 - 17:00.
[3Com]settr 8:30 12:00 14:00 17:00

3.1.13 timerange

Syntax
timerange { enable | disable }
View
System view
Parameter
enable: Enabling the timerange packet filter function.
disable: Disabling the timerange packet filter function.
Description
Using the timerange command, you can enable or disable the timerange packet filter
function.
By default, timerange disable.
This function is used to enable or disable the timerange filter function. The
configuration result can be displayed via the display firewall command, or via the
40