Chapter 1 L2Tp Configuration Commands; Allow L2Tp Virtual-Template - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00

Chapter 1 L2TP Configuration Commands

1.1 L2TP Configuration Commands

1.1.1 allow l2tp virtual-template

Syntax
allow l2tp virtual-template virtual-template-number [ remote remote-name ]
undo allow
View
L2TP group view
Parameter
virtual-template-number: Number of the virtual template used to create a new virtual
access interface, which is an integer in the range from 1 to 25.
remote-name: Name of a remote tunnel originating a tunnel connecting request. It is a
case-sensitive character string with the length ranging from 1 to 30 characters.
Description
Using the allow l2tp virtual-template command, you can configure the name of the
remote tunnel when accepting the call and the virtual template to be used. Using the
undo allow command, you can cancel the name of the remote tunnel.
By default, no call can be dialed in.
This command can only be configured on LNS. It is a required configuration.
When L2TP group 1 (default L2TP group number) is used, it is permitted to configure
group 1 without specifying remote-name, and the format of this command is:
allow l2tp virtual-template virtual-template-number [ remote remote-name ]
If the remote name is specified in L2TP group 1 view, then L2TP group 1 does not
serve as the default L2TP group. In Windows 2000 beta 2, for example, the local
tunnel name for the VPN connection is NONE, and the peer name received by the
2