Fr Lmi Type - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
Parameter
t392dce-value: value of the polling timer on a DCE, ranging 5s to 30s. The default value
is 15.
Description
Using the fr lmi t392dce command, you can configure the polling timer value on a DCE.
Using the undo fr lmi t392dce command, you can restore the default value.
This parameter defines the maximum time for DCE waiting for a Status-Enquiry, T392
should be greater than T391.
For related commands, see fr interface-type, fr lmi t391dte.
Example
# Set the operation of Frame Relay interface Serial0 as DCE mode and set T392 to
16s.
[3Com-Serial0]fr interface-type dce
[3Com-Serial0]fr lmi t392dce 16

6.1.37 fr lmi type

Syntax
fr lmi type { ansi | nonstandard | q933a } [ bi-direction ]
undo fr lmi type
View
Interface view
Parameter
ansi: ANSI T1.617 Annex D
nonstandard: Non standard.
q933a: ITU-T Q.933 Annex A.
bi-direction: Responds to the state query request from the network side, if the
interface works as Frame Relay DTE.
Description
Using the fr lmi type command, you can configure the Local Management
Interface(LMI) type. Using the undo fr lmi type command, you can restore the default
LMI type.
By default, LMI type is q933a.
The 3Com series routers usually supports three LMI protocols, that is, Q.933 Annex A,
ANSI T1.617 Annex D and Non-standard LMI.
120