3Com 3C13618 Command Reference Manual page 840

3Com Router Command Reference Guide — V1.00
Parameter
group-number: sequence number of dialer access number, ranges from 1 to 255. This
group is set through the dialer-rule command.
Description
Using the dialer-group command, you can configure access control on the packets
transmitted on a DCC interface and place the interface in a access control group.
Using the undo dialer-group command, you can cancel the interface from the
access control group.
By default, this command is not configured.
This command is used for associating a physical interface with a access control group.
Through the dialer-rule command, the user can associate a access control group
with the acl command. A DCC interface can only be the member of a access control
group. If it is configured to be a member of another access control group, this
configuration will replace the previous one.
Note:
In the default configuration of the interface, dialer-group is not configured. The user must configure this
command. Otherwise, DCC will be unable to transmit packets.
For related commands, see dialer-rule.
Example
# Add Serial0 interface to access control group 1.
[3Com] dialer-rule 1 acl 101
[3Com-Serial1] dialer-group 1
1.1.21 dialer-rule
Syntax
dialer-rule dialer-group { protocol-name { permit | deny } | acl acl-number }
undo dialer-rule dialer-group
View
System view
20