Igmp Host-Join; Igmp Max-Response-Time - 3Com 3C13618 Command Reference Manual

Example
# Specify the service range on serial port Serial0
[3Com] acl 5
[3Com-acl-5]rule permit source 225.0.0.0 0.255.255.255
[3Com-acl-5]interface serial 0
[3Com-Serial0] igmp group-policy 5 2

1.1.5 igmp host-join

Syntax
igmp host-join groups-address
undo igmp host-join groups-address
View
Interface view
Parameter
groups-address: Group address to be joined in the multicast group.
Description
Using the igmp host-join command, you can configure the router interface as a
member of multicast group. Using the undo igmp host-join command, you can
cancel the router interface from the group members.
If the equipment is configured as a group member and supports the protocol
being sent to the group, it has the response capability (such as ping command).
Such equipment responds to the request packet answering information sent to
IGMP where it locates.
For related commands, see igmp group-policy.
Example
# Join the serial port Serial0 in multicast group 225.0.0.1.
[3Com-Serial0] igmp host-join 225.0.0.1

1.1.6 igmp max-response-time

Syntax
igmp max-response-time seconds
undo igmp max-response-time
View
Interface view
Multicast Protocol
5