Bridge Routing-Enable; Bridge-Set - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
Example
# Enable the bridge set 1 to route IP packet.
[3Com]bridge 1 routing ip

8.1.8 bridge routing-enable

Syntax
bridge routing-enable
undo bridge routing-enable
View
System view
Parameter
None
Description
Using the bridge routing-enable command, you can enable the routing function of a
bridge. Using the undo bridge routing-enable command, you can disable the routing
function of a bridge.
By default, the routing function of a bridge is disabled.
A network layer protocol can be routed and bridged only when the routing function of a
bridge is enabled.
Example
# Enable the routing function of the bridge.
[3Com]bridge routing-enable

8.1.9 bridge-set

Syntax
bridge-set bridge-set
undo bridge-set bridge-set
View
Interface view
Parameter
bridge-set: Bridge set number, an integer in the range of 1 to 63.
148