X25 Vc-Per-Map - 3Com 3C13618 Command Reference Manual

View
Interface view
Parameter
seconds: Delay value of the clear indication retransmission timer in second.
Description
Using the x25 timer tx3 command, you can configure the delay value for clear
indication retransmission timer on a DTE/DCE. Using the undo x25 timer tx3
command, you can restore to the default value.
Default value for the clear indication retransmission timer on a DTE is 180 seconds;
default value for the clear indication retransmission timer on a DCE is 60 seconds.
According to X.25, a timer should be started when a DTE sends a clear request (or a
DCE sends a clear indication). If no remote acknowledgement is received after this
timer is timeout, the sending end will take some measures to guarantee the normal
proceeding of the local procedure. This parameter specifies the delay value of this timer
before the timeout.
For related commands, see x25 timer tx0, x25 timer tx1, x25 timer tx2.
Example
# Set the delay value of clear indication retransmission timer on the X.25 channel
interface serial0 to 100 seconds.
[3Com-Serial0]x25 timer tx3 100

5.1.50 x25 vc-per-map

Syntax
x25 vc-per-map count
undo x25 vc-per-map
View
Interface view
Parameter
count: number of VCs, ranging 1 to 8. By default, the count is 1.
Description
Using the x25 vc-per-map command, you can configure the maximum number for
vitual circuit that connects one device. Using the undo x25 vc-per-map command, you
can restore the maximum number for vitual circuit that connects one device to the
default value.
Link Layer Protocol
85