Snmp-Agent Target-Host - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
v3: Enable SNMPv3 operations.
all: Enable operations of SNMP of all versions.
Description
Using the snmp-agent sys-info version command, you can configure the version
that a network management station (NMS) can use to manage the SNMP agent.
Using the undo snmp-agent sys-info version command, you can restore the NMS
to use the default version to manage the agent.
By default, SNMPv3 operations are enabled.
Since SNMPv3 provides higher security, the system only enables the NMS to perform
SNMPv3 operations on the SNMP agent by default. You can use this command to
enable the NMS to perform SNMPv1 or SNMPv2 .
For related commands, see snmp-agent, snmp-agent community, snmp-agent
group, snmp-agent mib-view.
Example
# Enable the NMS to perform SNMPv1 operations on the SNMP agent.
[3Com] snmp-agent sys-info version v1

3.1.19 snmp-agent target-host

Syntax
snmp-agent target-host trap address host_address securityname name [ port
port ] [ parameters { v1 | v2c | v3 { authentication | noauthentication | privacy } } ]
undo snmp-agent target-host trap address host_address securityname name
[ port port ]
View
System view
Parameter
address host_address: IP address of the host receiving SNMP Trap messages.
port port: The UDP port number of host receiving SNMP Trap messages, ranging
form 0 to 65535.
parameters: Set the version of SNMP used in Trap messages.
56