Chapter 2 Gre Configuration Commands; Gre Protocol Configuration Commands - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00

Chapter 2 GRE Configuration Commands

2.1 GRE Protocol Configuration Commands

2.1.1 destination
Syntax
destination ip-address
undo destination
View
Tunnel interface view
Parameter
ip-address: IP address of the actual physical port at the remote tunnel interface.
Description
Using the destination command, you can configure IP address of remote tunnel
interface. Using the undo destination command, you can cancel the IP address of
remote tunnel interface.
The specified remote tunnel address is input in format of the IP address. It must be
the same as the actual physical address of the remote port attached and it should be
guaranteed that the route to this port is reachable. Furthermore, the destination
address of the tunnel configured at the local end must be consistent with the source
address of the remote tunnel.
For related commands, see interface tunnel, source.
Example
# Set up a tunnel connection between Serial0 in RouterA and Serial1 in RouterB; the
IP address of Serial0 in RouterA is 10.110.1.1, and that of Serial1 in RouterB is
20.110.1.1. Make the following configurations at tunnel0 in RouterA:
[RouterA] interface tunnel 0
[RouterA-Tunnel0] source 10.110.1.1
[RouterA-Tunnel0] destination 20.110.1.1
20