Network Service; Ppp Parameters; Ip Configuration (Network Service Ppp) - 3Com OfficeConnect 3CP4144 Cli User's Manual

3com officeconnect 3cp4144: users guide
Hide thumbs Also See for OfficeConnect 3CP4144:
Table of Contents

Advertisement

5-2
C
5: Q
VC S
HAPTER
UICK

Network Service

PPP Parameters

IP Configuration
(Network Service PPP)
ETUP
Enter the Peak Cell Rate:
The Category of Service and cell rate parameters only affect data transmitted from
the OfficeConnect Remote 812 to the remote site (upstream direction). The
default value of UBR with a Peak Cell Rate of 0 will attempt to use all available
upstream bandwidth when transmitting to the remote site.
The ATM Configuration for VC "name" is now complete.
The OfficeConnect Remote 812 suppports either PPP, PPPoE, or RFC 1483
encapsulation.
Question
Select the encapsulation type
(Only applicable if PPP or PPPoE is chosen as the network service.)
You must configure a name and password that will be used during the PPP
authentication process.
Question
What is the authentication name ?
What is the authentication password?
The authentication name for VC "name" is now complete.
(Only applicable if PPP is chosen as the network service.)
Network Address Translation (NAT) allows a single WAN-side IP address to be
'shared' by multiple LAN-side devices.
Local and remote IP adresses can be configured in two different ways:
Specified: the IP adress is always a specific address.
Learned: the IP address is learned when the PPP connection is established.
One active VC profile can have its remote router installed as the default router in
the OfficeConnect Remote 812's IP route table.
You can use Routing Information Protocol (RIP) to exchange routing information
with other routers on the network.
Question
Is IP traffic going to be routed over VC "name"?
Do you want to enable IP Network Address Translation (NAT)? [yes]
Is the remote IP address (S)pecified or (L)earned?
Enter the IP address of the router across the WAN: (specified
only)
Enter the IP mask for the router across the WAN: (specified
only)
[0]
Default
Your System
[ppp]
Default
Your System
[name]
[ ]
Default
[yes]
[L]
[ ]
[C]
Your System

Advertisement

Table of Contents
loading

This manual is also suitable for:

Officeconnect 812

Table of Contents