By default, the Resource-Shared DCC is not enabled, neither is dialer bundle
specified.
This command applies only to a dialer interface for configuring the dialer bundle that
the interface will use. Furthermore, a dialer interface can only use a dialer bundle.
This command can be used to not only enable Resource-Shared DCC but also
specify a dialer bundle used by a dialer interface, no matter what link-protocol, PPP or
Frame Relay, runs on the interface.
For related commands, see dialer bundle-member.
Example
# Configure the interface Dialer1 to use dialer bundle3, in which the interface Serial0
is included.
[3Com-Dialer1] dialer bundle 3
[3Com-Serial0] dialer bundle-member 3
1.1.4 dialer bundle-member
Syntax
dialer bundle-member number [ priority priority ]
undo dialer bundle-member number
View
Physical interface view
Parameter
number: Dialer bundle number ranging from 1 to 255.
priority: The priority of the physical interface in the dialer bundle, ranges from 1 to 127.
The physical interface with higher priority will be used first. This is an optional
parameter. By default, priority is 1.
Description
Using the dialer bundle-member command, you can configure a physical interface
included in a dialer bundle in the Resource-Shared DCC application. Using the undo
dialer bundle-member command, you can cancel the physical interface from the
dialer bundle.
By default, the physical interface is not assigned to any dialer bundle.
Dial-Up
5