Fr Inarp; Fr Interface-Type - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00

6.1.29 fr inarp

Syntax
fr inarp [ { ip | ipx } [ dlci ] ]
undo fr inarp [ { ip | ipx } [ dlci ] ]
View
Interface view
Parameter
ip: IP is supported for inverse address resolution .
ipx: IPX is supported for inverse address resolution .
dlci: data link connection identifier number, indicating that inverse address resolution is
performed for this DLCI only.
Description
Using the fr inarp command, you can enable the Inverse Address Resolution Protocol.
Using the undo fr inarp command, you can disable the use of protocol.
By default, the Inverse Address Resolution Protocol is enabled.
A DLCI-to-network address mapping must exist for frame relay to transmit data to a
destination. You can configure this mapping statically or by using frame relay inarp.
For related commands, see fr map, reset fr inarp-info, display fr map-info.
Example
# Enable inverse address resolution only on IP at the Frame Relay main interface
Serial0.
[3Com-Serial0]fr inarp ip

6.1.30 fr interface-type

Syntax
fr interface-type { dte | dce | nni }
undo fr interface-type
View
Interface view
Parameter
dte, dce and nni are three Frame Relay operations.
114