Bridge Routing - 3Com 3C13618 Command Reference Manual

interface-number: Interface number
Description
Using the bridge mac-address command, you can configure a static address table
entry of bridge. Using the undo bridge mac-address command, you can cancel the
static address entry.
By default, no static address is configured.
Normally, an address table is generated according to the relations of the MAC
addresses obtained by the bridge. However, there are still some static address entries
in the bridging address tables, which are manually configured and maintained by
administrators and will never become aged.
Example
# Enable the interface Ethernet 0 to forward the frames with the MAC address
00-00-00-00-01-11.
[3Com]bridge 1 mac-address 00-00-00-00-01-11 permit Ethernet 0

8.1.7 bridge routing

Syntax
bridge bridge-set routing { ip | ipx }
undo bridge bridge-set routing { ip | ipx }
View
System view
Parameter
bridge-set: Bridge set number in the range of 1 to 63.
ip: Internet Protocol.
ipx: Internet Packet Exchange Protocol.
Description
Using the bridge routing command, you can enable a specified bridge set to route a
network layer protocol. Using the undo bridge routing command, you can disable the
specified bridge set to route the protocol.
By default, routing function of bridge set is disabled.
If a bridge is configured to route a network layer protocol, it will route the packets of the
protocol that require routing.
Link Layer Protocol
147