Display Dialer Interface - 3Com 3C13618 Command Reference Manual

Parameter
dialer-group: Number of access control group corresponding to dialer-group
group-number in the DCC interface configuration.
protocol-name: Network protocol, the value can be ip, ipx or bridge.
permit: Permits the packets of the specified protocol.
deny: Denies the packets of the specified protocol.
acl acl-number: Number of the access control list to which the access control group
corresponds.
Description
Using the dialer-rule command, you can configure the conditions of the data packet
that can trigger a DCC call. Using the undo dialer-rule command, you can cancel the
setting.
By default, no conditions of packet-triggering DCC calls are set for dial interfaces.
This command is used to set the DCC call packet-triggering control to which a access
control group corresponds. And a dial interface can be placed in a access control
group through the dialer-group command. Thereby, the DCC call's packet-triggering
on the DCC interface can be controlled.
If a access control group cannot find the corresponding dialer-rule, DCC will regard
the packets as packets which do not comply with the "permit" conditions in ACL rule
and just drop them. No DCC call will be originated.
For related commands, see dialer-group.
Example
# Set a dialer-rule.
[3Com] acl 101
[3Com-acl-101] rule permit ip source 0.0.0.0 255.255.255.255 destination 0.0.0.0
255.255.255.255
[3Com] dialer-rule 1 acl 101
[3Com-Serial1] dialer-group 1

1.1.22 display dialer interface

Syntax
display dialer interface [ interface-type interface-number ]
Dial-Up
21