10-2-3 Checking the Displays
7-Segment Display
The 7-segment display is on the front panel.
When the power is turned ON, it shows the node address that is set by the rotary switches. Then the
display changes according to the setting of the LED Display Selection (3700 hex).
An error code is displayed if an error occurs. A warning code is displayed if a warning occurs.
Node Address Display
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
Control power ON
A
To
on the next page
Fully OFF
Fully ON
"nA" (node address, approx. 0.6 s)
Rotary switch setting
(upper digit (×10) = 0, lower digit (×1) = 3)
(It lasts for the period set in the Power ON Address
Display Duration Setting (3701 hex).)
10 Operation
10
10-5