Omron R88D-KN series User Manual page 108

3 Specifications
Connector-Terminal Block Conversion Unit (XW2B-20G)
The Unit is used with a Connector Terminal Block Cable (XW2Z-J-B34). They convert the control
input signal (CN1) of the G5-series Servo Drive into a terminal block.
 Terminal Block Models
Model
XW2B-20G4
XW2B-20G5
XW2D-20G6
 XW2B-20G4
Precautions for Correct Use Precautions for Correct Use
• Use 0.3 to 1.25 mm
• The wire inlet of M3 screw terminal block is 1.8 mm (height)  2.5 mm (width).
• Strip the insulation from the end of the wire for 6 mm as shown below.
3-34
Description
M3 screw terminal block
M3.5 screw terminal block
M3 screw terminal block
Dimensions
Flat cable connector (MIL type plug)
3.5
2
1
1
2
2
wire (AWG22 to 16).
6mm
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
67.5 3.5
20
19
19
2-
Ø
20
Terminal block
5.08
3.5