Ethercat Communications Cable Specifications - Omron R88D-KN series User Manual

Safety I/O Signal Connector (R88A-CNK81S)
Use this connector to connect to a safety device.
Pin arrangement
Note 1 The recommended cable is a 6-core shielded cable with a wire size of AWG30 to AWG26 and a finished
outer diameter of 6.7 mm or less.
2 For information on wiring, refer to Safety Connector Specifications (CN8) on page 3-23.
3-3-3

EtherCAT Communications Cable Specifications

For the EtherCAT communications cable, use an Ethernet Category 5 (100BASE-TX) or higher twisted-
pair cable (with double, aluminum tape and braided shielding).
Recommended cable is shown below.
Recommended Cable
Size x Number of cable cores
(pairs)
AWG24 x 4P
AWG22 x 2P
*1 It is recommended that you use this cable in combination with the OMRON XS6G-T421-1 connector.
Precautions for Correct Use Precautions for Correct Use
The maximum length between nodes is 100 m. However, some cables are specified for less than
100 m. Generally speaking, if the conductors are twisted wire rather than solid wire, transmission
performance will be lower, and reliable communications may not be possible at 100 m. Confirm
details with the cable manufacturer.
Additional Information
If an Ethernet cable of Ethernet Category 5 (100BASE-TX) or higher is used, communications
will be possible even if the cable is not shielded. However, we recommend a cable with double,
aluminum tape and braided shielding to ensure sufficient noise immunity.
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
11
33
Recommended manufacturer
Tonichi kyosan Cable, Ltd.
Kuramo Electric Co.
SWCC Showa Cable Systems Co.
Kuramo Electric Co.
3 Specifications
6.7
Ø
Model
NETSTAR-C5E SAB 0.5  4P
KETH-SB
FAE-5004
*1
KETH-PSB-OMR
3
3-29