Omron R88D-KN series User Manual page 536

Appendicies
Event name Interface Output Function Number Error 1
Meaning There is an undefined number specification in the output signal (OUTM1) function allocation.
Source EtherCAT Master Function Module
Error attributes Level
Effects User program
Indicators EtherNet/IP NET RUN
---
System-defined Variable
variables
None
Cause and Assumed cause
correction
There is an undefined number
specification in the output signal
(OUTM1) function allocation.
Attached None
information
Precautions/ "33" is displayed on the Servo Drive front panel and F433 is given as the AlarmCode (4001 hex).
Remarks
Event name Interface Output Function Number Error 2
Meaning There is an undefined number specification in the output signal (OUTM2) function allocation.
Source EtherCAT Master Function Module
Error attributes Level
Effects User program
Indicators EtherNet/IP NET RUN
---
System-defined Variable
variables
None
Cause and Assumed cause
correction
There is an undefined number
specification in the output signal
(OUTM2) function allocation.
Attached None
information
Precautions/ "33" is displayed on the Servo Drive front panel and F533 is given as the AlarmCode (4001 hex).
Remarks
A-136
Source details
Minor fault Recovery
Continues. Operation
EtherNet/IP NET ERR
---
Data type
---
Remedy
Allocate the functions to the
connector pins using only the
numbers that are defined.
Source details
Minor fault Recovery
Continues. Operation
EtherNet/IP NET ERR
---
Data type
---
Remedy
Allocate the functions to the
connector pins using only the
numbers that are defined.
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
Event code 38490000 hex
Slave Detection
timing
Error reset (after Log category
cycling slave
power)
Power drive circuit is OFF for relevant slave.
EtherNet/IP LINK/ACT
---
Name
---
Prevention
Allocate the functions to the
connector pins using only the
numbers that are defined.
Event code 384A0000 hex
Slave Detection
timing
Error reset (after Log category
cycling slave
power)
Power drive circuit is OFF for relevant slave.
EtherNet/IP LINK/ACT
---
Name
---
Prevention
Allocate the functions to the
connector pins using only the
numbers that are defined.
When
establishing
communications
after turning ON
power to the
slave or when
transferring
EtherCAT
Configuration
Setup
System
When
establishing
communications
after turning ON
power to the
slave or when
transferring
EtherCAT
Configuration
Setup
System