Omron R88D-KN series User Manual page 525

Event name Servo Drive Overheat
Meaning The temperature of the Servo Drive radiator or power elements exceeded the specified value.
Source EtherCAT Master Function Module
Error attributes Level
Effects User program
Indicators EtherNet/IP NET RUN
---
System-defined Variable
variables
None
Cause and Assumed cause
correction
The ambient temperature of the
Servo Drive exceeded the specified
value.
Overload
Attached None
information
Precautions/ "15" is displayed on the Servo Drive front panel and F015 is given as the AlarmCode (4001 hex)
Remarks
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
Source details
Minor fault Recovery
Continues. Operation
EtherNet/IP NET ERR
---
Data type
---
Remedy
Improve the ambient temperature and
the cooling conditions of the Servo
Drive.
Increase the capacities of the Servo
Drive and the motor. Or, increase the
setting of the acceleration/
deceleration time and lighten the
load.
Event code 34E10000 hex
Slave Detection
timing
Error reset (after Log category
cycling slave
power)
Power drive circuit is OFF for relevant slave.
EtherNet/IP LINK/ACT
---
Name
---
Prevention
Check the ambient temperature of the
Servo Drive and set up the necessary
cooling conditions.
Increase the setting of the
acceleration/deceleration time and
lighten the load as much as possible.
Appendicies
Continuously
System
A-125