Omron R88D-KN series User Manual page 551

Event name Communications Setting Error
Meaning There is an error in the communications settings.
Source EtherCAT Master Function Module
Error attributes Level
Effects User program
Indicators EtherNet/IP NET RUN
---
System-defined Variable
variables
None
Cause and Assumed cause
correction
An out-of-range value was set from
the host controller.
A command that changes the
communications state to an
unsupported state was received.
Attached None
information
Precautions/ "90" is displayed on the Servo Drive front panel and F090 is given as the AlarmCode (4001 hex).
Remarks
Event name Synchronization Interruption Error
Meaning A synchronization interruption error occurred.
Source EtherCAT Master Function Module
Error attributes Level
Effects User program
Indicators EtherNet/IP NET RUN
---
System-defined Variable
variables
None
Cause and Assumed cause
correction
Control PCB error
Attached None
information
Precautions/ "88" is displayed on the Servo Drive front panel and F288 is given as the AlarmCode (4001 hex)
Remarks
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
Source details
Minor fault Recovery
Continues. Operation
EtherNet/IP NET ERR
Flashes at 1-s intervals.
Data type
---
Remedy
Set EtherCAT communications
parameters so that the synchronous
cycle (SYNC0 cycle) and other setting
are within the specified ranges.
Check the command specifications
for communications state transitions
in the host controller and correct host
controller processing.
Source details
Minor fault Recovery
Continues. Operation
EtherNet/IP NET ERR
Flashes at 1-s intervals.
Data type
---
Remedy
Replace the Servo Drive.
Event code 84B80000 hex
Slave Detection
timing
Error reset (after Log category
resetting slave
errors)
Power drive circuit is OFF for relevant slave.
EtherNet/IP LINK/ACT
---
Name
---
Prevention
Set EtherCAT communications
parameters so that the synchronous
cycle (SYNC0 cycle) and other setting
are within the specified ranges.
Check the command specifications
for communications state transitions
in the host controller and program
host controller processing.
Event code 84B90000 hex
Slave Detection
timing
Error reset (after Log category
cycling slave
power)
Power drive circuit is OFF for relevant slave.
EtherNet/IP LINK/ACT
---
Name
---
Prevention
None
Appendicies
Continuously
System
Continuously
System
A-151