Omron R88D-KN series User Manual page 520

Appendicies
Event name Object Error
Meaning The object area data in non-volatile memory is corrupted.
Source EtherCAT Master Function Module
Error attributes Level
Effects User program
Indicators EtherNet/IP NET RUN
---
System-defined Variable
variables
None
Cause and Assumed cause
correction
Noise
Non-volatile memory failure
Attached None
information
Precautions/ "36" is displayed on the Servo Drive front panel and F136 is given as the AlarmCode (4001 hex).
Remarks
Event name Object Error
Meaning The object area data in non-volatile memory is corrupted.
Source EtherCAT Master Function Module
Error attributes Level
Effects User program
Indicators EtherNet/IP NET RUN
---
System-defined Variable
variables
None
Cause and Assumed cause
correction
Noise
Non-volatile memory failure
Attached None
information
Precautions/ "36" is displayed on the Servo Drive front panel and F236 is given as the AlarmCode (4001 hex).
Remarks
A-120
Source details
Minor fault Recovery
Continues. Operation
EtherNet/IP NET ERR
---
Data type
---
Remedy
Reset all of the objects. Implement
noise countermeasures.
If the error persists, replace the Servo
Drive.
Source details
Minor fault Recovery
Continues. Operation
EtherNet/IP NET ERR
---
Data type
---
Remedy
Reset all of the objects. Implement
noise countermeasures.
If the error persists, replace the Servo
Drive.
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
Event code 14A90000 hex
Slave Detection
timing
Error reset (after Log category
cycling slave
power)
Power drive circuit is OFF for relevant slave.
EtherNet/IP LINK/ACT
---
Name
---
Prevention
Reset all of the objects. Implement
noise countermeasures.
None
Event code 14AA0000 hex
Slave Detection
timing
Error reset (after Log category
cycling slave
power)
Power drive circuit is OFF for relevant slave.
EtherNet/IP LINK/ACT
---
Name
---
Prevention
Reset all of the objects. Implement
noise countermeasures.
None
When
establishing
communications
after turning ON
power to the
slave
System
When
establishing
communications
after turning ON
power to the
slave
System