Omron R88D-KN series User Manual page 104

3 Specifications
Recommended Connector (Modular Plug)
Use a shielded connector of Ethernet Category 5 (100BASE-TX) or higher.
Recommended connector is shown below.
Size x Number of cable
cores (pairs)
AWG24 x 4P
AWG22 x 2P
*1 It is recommended that you use this connector in combination with the Kuramo Electric Co. KETH-PSB-OMR
cable.
Precautions for Correct Use Precautions for Correct Use
When selecting a connector, confirm that it is applicable to the cable that will be used. Confirm
the following items: Conductor size, conductor type (solid wire or twisted wire), number of twisted
pairs (2 or 4), outer diameter, etc.
Attaching the Connectors to the Cable
Use straight wiring for the communications cable, as shown below.
Pin No.
1
2
3
4
5
6
7
8
Connector hood
Note 1 Connect the cable shield to the connector hood at both ends of the cable.
2 There are two connection methods for Ethernet: T568A and T568B. The T568A connection
method is shown above, but the T568B connection method can also be used.
3-30
Recommended
manufacturer
Panduit Corporation
OMRON Corporation
Wire color
White-Green
Green
White-Orange
Blue
White-Blue
Orange
White-Brown
Brown
Shield
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
Model
MPS588
*1
XS6G-T421-1
Wire color
White-Green
Green
White-Orange
Blue
White-Blue
Orange
White-Brown
Brown
Shield
Contacts
Panduit Corporation
Japan Branch Osaka
Sales Office
OMRON Corporation
Customer Support
Pin No.
1
2
3
4
5
6
7
8
Connector hood