Omron R88D-KN series User Manual page 22

Safety Precautions
Operation and Adjustment
If the Servo Drive fails, cut off the power supply to the Servo Drive at the power supply.
Fire may result.
Conduct a test operation after confirming that the equipment is not affected.
Equipment damage may result.
Before operating the Servo Drive in an actual environment, check if it operates correctly
based on the parameters and switches you have set.
Equipment damage may result.
Never adjust or set parameters to extreme values, because it will make the operation
unstable.
Injury may result.
Separate the Servomotor from the mechanical system and check its operation before
installing the Servomotor to the machine.
Injury may result.
If an error occurs, remove the cause of the error and ensure safety, and then reset the
alarm and restart the operation.
Injury may result.
Do not operate the Linear Motor connected to an excessive load mass.
Failure may result.
Do not turn ON and OFF the main Servo Drive power supply frequently.
Failure may result.
Maintenance and Inspection
Never repair the Servo Drive by disassembling it.
Electric shock or injury may result.
After replacing the Servo Drive, transfer to the new Servo Drive all data needed to resume
operation, before restarting operation.
Equipment damage may result.
Be sure to turn OFF the power supply when the Servo Drive is not going to be used for a
prolonged period of time.
Injury may result.
20
Caution
Caution
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type