Omron R88D-KN series User Manual page 552

Appendicies
Event name Position Data Initialized
Meaning A Config operation was performed during EtherCAT communications.
Source EtherCAT Master Function Module
Error attributes Level
Effects User program
Indicators EtherNet/IP NET RUN
---
System-defined Variable
variables
None
Cause and Assumed cause
correction
A Config operation was performed
during EtherCAT communications.
Attached None
information
Precautions/ "27" is displayed on the Servo Drive front panel and F727 is given as the AlarmCode (4001 hex)
Remarks
Event name Fan Warning
Meaning The fan stop state continued for 1 second.
Source EtherCAT Master Function Module
Error attributes Level
Effects User program
Indicators EtherNet/IP NET RUN
---
System-defined Variable
variables
None
Cause and Assumed cause
correction
There is foreign matter in the fan.
The Servo Drive failed.
Attached None
information
Precautions/ "A3" is displayed on the front panel of the Servo Drive.
Remarks
A-152
Source details
Minor fault Recovery
Continues. Operation
EtherNet/IP NET ERR
---
Data type
---
Remedy
This operation is performed for safety
and is not an error.
Source details
Observation Recovery
Continues. Operation
EtherNet/IP NET ERR
---
Data type
---
Remedy
If there is foreign matter in the fan,
remove it.
If the above cause is not the cause of
the problem, replace the Servo Drive.
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
Event code 98020000 hex
Slave Detection
timing
Error reset (after Log category
resetting slave
errors)
Power drive circuit is OFF for relevant slave.
EtherNet/IP LINK/ACT
---
Name
---
Prevention
(A preventative measure is not
required because this is a safety
measure.)
Event code 08020000 hex
Slave Detection
timing
--- Log category
Not affected.
EtherNet/IP LINK/ACT
---
Name
---
Prevention
Do not use the fan in an area
surrounded by excessive foreign
matter. Also, do not allow foreign
objects to enter.
None
Continuously
System
Continuously
System