Switchport Port-Security - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

S C
WITCHING OMMANDS
-
SWITCHPORT PORT SECURITY

switchport port-security

Overview Use this command to enable the port-security feature. This feature is also known
as the port-based learn limit. It allows the user to set the maximum number of MAC
addresses that each port can learn.
Use the no variant of this command to disable the port-security feature.
Syntax switchport port-security
no switchport port-security
Mode Interface Configuration
Examples To enable the port-security feature on port1.0.4, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable the port-security feature on port1.0.4, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related clear port-security intrusion
Commands
show port-security interface
show port-security intrusion
switchport port-security aging
switchport port-security maximum
switchport port-security violation
613-50157-01 Rev C
configure terminal
interface port1.0.4
switchport port-security
configure terminal
interface port1.0.4
no switchport port-security
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
400