Boot Config-File - Allied Telesis AT-x930-28GTX Command Reference Manual

F C M
ILE AND ONFIGURATION ANAGEMENT
-
BOOT CONFIG FILE

boot config-file

Overview Use this command to set the configuration file to use during the next boot cycle.
Use the no variant of this command to remove the configuration file.
Syntax boot config-file <filepath-filename>
no boot config-file
Mode Global Configuration
Usage You can only specify that the configuration file is on a USB storage device if there
is a backup configuration file already specified in Flash. If you attempt to set the
configuration file on a USB storage device and a backup configuration file is not
specified in Flash, the following error message is displayed:
For an explanation of the configuration fallback order, see the
Feature Overview and Configuration
Examples To run the configuration file "branch.cfg" stored on the device's Flash filesystem
the next time the device boots up, use the commands:
awplus#
awplus(config)#
To stop running the configuration file "branch.cfg" stored on the device's Flash
filesystem when the device boots up, use the commands:
awplus#
awplus(config)#
To run the configuration file "branch.cfg" stored on the switch's USB storage
device filesystem the next time the device boots up, use the commands:
awplus#
awplus(config)#
C613-50100-01 REV C
C
OMMANDS
Parameter
<filepath-filename>
% Backup configuration files must be stored in the flash 
filesystem
configure terminal
boot config-file flash:/branch.cfg
configure terminal
no boot config-file flash:/branch.cfg
configure terminal
boot config-file usb:/branch.cfg
Command Reference for x930 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Filepath and name of a configuration file.
The specified configuration file must exist in the
specified filesystem.
Valid configuration files must have a . cfg extension.
Guide.
File Management
119