Audit Log Setup - Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions

Chapter 5 Setup
5.2 ETERNUS DX Disk Storage System Monitoring Setup
5.2.6

Audit Log Setup

Audit trail logs (hereinafter referred to as "audit log") that record performed operations by using the ETERNUS
DX Disk storage system and the system actions that are associated with these operations can be sent to the
specified syslog server (external server).
• Up to two syslog servers can be specified.
• After the environmental settings for audit logs are complete, confirm that the audit log is successfully
received on the syslog server.
• Even if a communication error occurs between the ETERNUS DX Disk storage system and the syslog server,
the audit log is not sent again.
The audit log setting is explained below.
Procedure
1
Start ETERNUS Web GUI.
2
On the navigation of ETERNUS Web GUI screen, click [System].
The [System] screen appears.
3
In [Category], click [Audit Log].
The [Audit Log] screen appears.
4
If "Disable" is specified for "Audit Log", select "Enable".
4-1
Click [Enable Audit Log] in [Action].
A confirmation screen appears.
4-2
Click the [OK] button.
Enabling of the audit log starts.
4-3
Check the setting completion message and click the [Done] button.
The screen display returns to the [Audit Log] screen.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
138
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0