Jeep 1987 Wrangler Workshop Manual page 161

WELDED COMPONENTS
REAR BODY COLLISION REPAIRS
If required, straighten the floor pan
reinforcements.
NOTE: The additional size (Z) for the section
may vary according to the width of the flange
tool.
100609
Use a flange tool (A) to flange the mating edge
of the remaining original floor pan section (B).
101452
Drill a series of 4mm (0.15 in) diameter holes
spaced 36mm (.15 in) apart, along the mating
edge of the replacement floor pan section (C).
4 mm
&
zzzzzzzzzzzzzzzz^^
100610
Remove the primer from the areas to be welded
on the replacement floor pan section.
Remove the primer from the areas to be welded
on the replacement floor pan section.
REAR FLOOR PAN — INSTALLATION
PREPARATION
Apply anti-corrosion sealant/primer to the ar-
eas to be welded:
% spotwelds - weld through the sealant
# MIG welders - weld through zinc-based
primer
SEE
I.S.
N
O
T
E
S
•
S-59