Fuel Level Sensor Inspection - Honda Transalp XL700V Manual

FUEL LEVEL SENSOR INSPECTION

Remove the fuel pump (page 5-59).
Connect an ohmmeter to the fuel pump 3P (Natural)
connector Black/white and Red/black terminals.
Inspect the resistance of the float at the full and
empty positions.
Position
Resistance
Replace the fuel pump assembly if fuel level sensor
is out of specification.
Install the fuel pump (page 5-59).
FUEL METER INSPECTION
Remove the fuel pump (page 5-59).
Connect the fuel pump 3P (Natural) connector.
Turn the ignition switch ON.
Move the float from the empty to check full position,
Keep the float at
then check the fuel meter indication.
each position in
several tens of
If the fuel meter does not indicate properly, check
seconds.
for open or short circuit in wire harness.
If the wire harness is good, replace the combination
meter assembly (page 20-10).
FULL EMPTY
8 – 12 Ω 233 – 240 Ω
LIGHTS/METERS/SWITCHES
FLOAT
3P (NATURAL) CONNECTOR
3P (NATURAL) CONNECTOR
(Wire side/male terminal)
R/Bl
FULL:
EMPTY:
Bl/W
20-17