Remove the bolts and regulator/rectifier.
Install the regulator/rectifier in the reverse order of
removal.
ALTERNATOR CHARGING COIL
INSPECTION
Remove the left side cover (page 2-4).
With the ignition switch turned OFF, disconnect the
alternator 3P (Natural) connector.
Measure the resistance between the Yellow wire
terminals.
STANDARD: 0.1 – 1.0 Ω at 20°C (68°F)
Check for continuity between each wire terminals of
the alternator/stator side connector and ground.
There should be no continuity.
Replace the stator if the resistance is out of specifi-
cation, or if any wire has continuity to ground.
For alternator/starter replacement (page 11-4).
BATTERY/CHARGING SYSTEM
REGULATOR/RECTIFIER
3P (NATURAL) CONNECTOR
BOLTS
17-9