Honda Transalp XL700V Manual page 448

Install new brake pads into the caliper so their ends
Make sure the pad
rest into the pad retainer on the bracket properly.
spring is installed
correctly.
Apply silicone grease to the pad pin stopper ring
sliding surface.
Install the pad pin by pushing in the pads against
Always replace the
the pad spring to align the pad pin holes in the pads
brake pads in pairs
and caliper body.
to ensure even disc
pressure.
Tighten the pad pin to the specified torque.
TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)
Operate the brake lever to seat the caliper piston
against the pads.
REAR
Push the caliper piston all the way in to allow instal-
Check the brake
lation of new brake pads.
fluid level in the
reservoir as this
operation causes
the level to rise.
Loosen the pad pin.
Remove the rear brake caliper mounting bolt.
HYDRAULIC BRAKE
STOPPER RING
BOLT
PADS
RETAINER
PAD PIN
PAD PIN
15-19