Rear Wheel Speed Sensor - Honda Transalp XL700V Manual

Hide thumbs Also See for Transalp XL700V:

Table of Contents

ANTI-LOCK BRAKE SYSTEM (ABS)

Remove the bolt, then release the wheel speed sen-

sor wire from the clamp.

Remove the bolts, sensor cover, wire clamp and

front wheel speed sensor.

Check that there is iron or other magnetic deposits

between the pulser ring and front wheel speed sen-

Remove any deposits.

Check the sensor tip for deformation or damage

(e.g., chipped pulser ring teeth).

Replace the front wheel speed sensor if necessary.

Installation is in the reverse order of removal.

Route the sensor

wire properly (page

After installing the speed sensor, Measure the clear-

ance (air gap) between the sensor and pulser ring

(page 16-21).

REAR WHEEL SPEED SENSOR/VS

Support the motorcycle securely and raise the rear

wheel off the ground.

Measure the clearance (air gap) between the rear

wheel speed sensor/VS sensor and pulser ring at

several points by turning the wheel slowly.

It must be within specification.

STANDARD: 0.4 – 1.2 mm (0.02 – 0.05 in)

The sensor air gap cannot be adjusted.

If it is not within specification, check each installed

part for deformation, looseness and damage.

FRONT WHEEL SPEED SENSOR

Show Quick Links

Chapters

Table of Contents

Transalp xl700va