2. Manifold Absolute Pressure Test
Turn the ignition switch OFF.
Check for connection and installation of the MAP
sensor vacuum hose.
Is the MAP sensor vacuum hose connection cor-
rect?
YES
– GO TO STEP 3.
NO
– Correct the hose installation
3. MAP Sensor System Inspection
Replace the MAP sensor with a known good one
(page 5-71).
Turn the ignition switch ON and engine stop
switch " ".
Start the engine and check the MAP sensor with
the HDS at idle speed.
Is the reading changed?
YES
– Faulty original MAP sensor
NO
– Replace the ECM with a new one, and
recheck; for Key Registration Proce-
dures (page 21-4).
DTC 7-1 (ECT SENSOR LOW
VOLTAGE)
• Before starting the inspection, check for loose or
poor contact on the ECT sensor 3P (Gray) con-
nector and ECM 33P connectors, then recheck
the DTC.
1. ECT Sensor System Inspection
Turn the ignition switch ON and engine stop
switch " ".
Check the ECT sensor with the HDS.
Is about 0 V indicated?
NO
– Intermittent failure
YES
– GO TO STEP 2.
2. ECT Sensor Inspection
Turn the ignition switch OFF.
Disconnect the ECT sensor 3P (Gray) connector.
Turn the ignition switch ON and engine stop
switch " ".
Check the ECT sensor with the HDS.
Is about 0 V indicated?
NO
– GO TO STEP 3.
YES
– GO TO STEP 4.
FUEL SYSTEM (PGM-FI)
VACUUM HOSE
5-21