Honda Transalp XL700V Manual page 329

ALTERNATOR/STARTER CLUTCH
Install the alternator wire to the wire guide.
Connect the alternator 3P (Natural) connector.
Install the alternator wire to the wire band and har-
Route the wire
ness clamp.
harness properly
(page 1-21).
Install the ECM stay and trim clip (XL700VA only).
Install and tighten the nut, bolt/washer and bolt
securely.
Install the following:
– Drive sprocket cover (page 7-13)
– Heat guard plate mounting bolt (page 2-23)
– ECM (page 5-77)
– Under cowl (page 2-13)
– Left front side cowl (page 2-9)
Check the engine oil level (page 3-12).
11-14
WIRE GUIDE
WIRE BAND
3P (NATURAL) CONNECTOR
STAY
BOLT
ALTERNATOR WIRE
HARNESS CLAMP
NUT
CLIP
(XL700VA)
BOLT/WASHER