Honda Transalp XL700V Manual page 418

CUSHION ARM
Remove the pivot collars and dust seals.
Press the needle bearings out of the cushion arm
using the special tools.
TOOLS:
Shock absorber side:
Driver handle
Attachment, 22 x 24 mm
Pilot, 17 mm
Swingarm side:
Needle bearing pusher
Pack a new needle bearing with specified grease
(page 1-18).
Press the shock absorber side needle bearing into
the cushion arm so that the needle bearing surface
is lower 5.3 – 5.7 mm (0.21 – 0.22 in) from the end of
the cushion arm using the special tools.
TOOLS:
Driver
Attachment, 22 x 24 mm
Pilot, 17 mm
Pack a new needle bearings with specified grease
(page 1-18).
Press the swingarm side needle bearings into the
cushion arm so that the needle bearings surface are
lower 5.5 – 6.0 mm (0.22 – 0.24 in) from the end of
the cushion arm using the special tool.
TOOL:
Needle bearing pusher
DUST SEALS
SHOCK ABSORBER
SIDE:
070GD-0010100
07746-0010800
07746-0040400
07946-KA50000
DRIVER
07749-0010000
07746-0010800
07746-0040400
ATTACHMENT/
PILOT
NEEDLE BEARING
PUSHER
07946-KA50000
REAR WHEEL/SUSPENSION
DUST SEALS
SWINGARM SIDE:
5.3 – 5.7 mm
(0.21 – 0.22 in)
NEEDLE BEARING
5.5 – 6.0 mm
(0.22 – 0.24 in)
NEEDLE BEARINGS
COLLARS
14-19