SIDE CLEARANCE INSPECTION
Before removing the connecting rods, check the big
end side clearance.
Measure the side clearance by inserting the feeler
gauge between the crankshaft and connecting rod
big end.
SERVICE LIMIT: 0.40 mm (0.016 in)
CONNECTING ROD REMOVAL
Remove the crankpin bearing cap nuts and the bear-
Tap the side of the
ing caps.
cap lightly if bearing
cap is hard to
remove.
Mark the rods, bearings and caps as you remove
them to indicate the correct cylinder and position on
the crankpins for reassembly.
For the connecting rod small end inspection (page
9-7).
CRANKCASE/CRANKSHAFT/TRANSMISSION
FEELER GAUGE
NUTS
CONNECTING ROD
CAPS
BEARING CAP
BEARINGS
12-9