Honda Transalp XL700V Manual page 409

REAR WHEEL/SUSPENSION
Install the driven flange collar in a new driven flange
bearing until it is fully seated.
TOOLS:
Driver
Attachment, 37 x 40 mm
Pilot, 17 mm
Install the driven flange bearing/collar into the
driven flange using the special tools.
TOOLS:
Driver
Attachment, 52 x 55 mm
Pilot, 17 mm
WHEEL BEARING REPLACEMENT
Install the remover head into the bearing.
Replace the wheel/
From the opposite side of the wheel, install the
driven flange
remover shaft and drive the bearing out of the
bearings as a set.
wheel hub.
Do not reuse old
Remove the distance collar and drive out the other
bearing.
bearing.
TOOLS:
Bearing remover shaft
Bearing remover head, 17 mm
Drive in a new right bearing squarely with the
marked side facing up until it is fully seated.
Install the distance collar.
Drive in a new left bearing squarely with the marked
side facing up until it is fully seated.
TOOLS:
Right side:
Driver
Attachment, 42 x 47 mm
Pilot, 17 mm
Left side:
Driver
Attachment, 37 x 40 mm
Pilot, 17 mm
14-10
DRIVER
07749-0010000
07746-0010200
07746-0040400
COLLAR
DRIVER
07749-0010000
07746-0010400
07746-0040400
07GGD-0010100
07746-0050500
REMOVER HEAD
DRIVER
07749-0010000
07746-0010300
07746-0040400
07749-0010000
07746-0010200
07746-0040400
ATTACHMENT
PILOT
ATTACHMENT
PILOT
REMOVER SHAFT
ATTACHMENT
PILOT