Honda Transalp XL700V Manual page 379

FRONT WHEEL/SUSPENSION/STEERING
To balance the wheel, install a new balance weight
on the lightest side of the spoke, the side opposite
the chalk marks. Add just enough weight so the
wheel will no longer stop in the same position when
it is spun.
Do not add more than 60 g (2.1 oz) to the front
wheel.
DISASSEMBLY
Remove the torx bolts and pulser ring.
XL700VA only:
Remove the dust seals.
Remove the bolts, brake discs and hub covers from
Do not reuse the
both sides of the wheel.
bolts.
WHEEL BEARING REPLACEMENT
Install the remover head into the bearing.
Replace the wheel
From the opposite side of the wheel, install the
bearings in pairs.
remover shaft and drive the bearing out of the
Do not reuse old
wheel hub.
bearing.
Remove the distance collar and drive out the other
bearing.
TOOLS:
Bearing remover shaft
Bearing remover head, 17 mm
13-18
BALANCE WEIGHT
PULSER RING
(XL700VA)
BRAKE DISC
HUB COVERS
07GGD-0010100
07746-0050500
REMOVER HEAD
TORX BOLTS
(XL700VA)
DUST SEALS
BOLTS
REMOVER SHAFT