Front Master Cylinder - Honda Transalp XL700V Manual

Measure the brake disc warpage with a dial indica-
tor.
SERVICE LIMITS:
FRONT: 0.30 mm (0.012 in)
REAR:
Check the bearing for excessive play, if the warpage
exceeds the service limit.
Replace the brake disc if the bearings are normal.
For brake disc replacement (page 13-15).

FRONT MASTER CYLINDER

REMOVAL
Drain the brake fluid from the hydraulic system.
– XL700V (page 15-7)
– XL700VA (page 15-11)
Remove the knuckle guard and brake lever (page 13-
7).
Disconnect the front brake light switch connectors.
Remove the oil bolt and sealing washers.
When removing the
oil bolt, cover the
end of the hose to
prevent
contamination.
Remove the bolts, holder and master cylinder.
DISASSEMBLY
Remove the screw and front brake light switch.
0.30 mm (0.012 in)
HYDRAULIC BRAKE
BRAKE HOSE CONNECTORS
OIL BOLT SEALING WASHERS
MASTER CYLINDER
SCREW
HOLDER
BOLTS
SWITCH
15-21