Honda Transalp XL700V Manual page 310

Install the oil pump drive chain, drive sprocket and
driven sprocket as a set.
• Install the driven sprocket with its " " mark fac-
ing outside.
• Align the flat surfaces of the driven sprocket hole
and oil pump shaft end.
Apply locking agent to the oil pump driven sprocket
bolt threads (page 1-18).
Install the washer and bolt.
Tighten the driven sprocket bolt to the specified
torque after installing the clutch.
Install the clutch outer onto the mainshaft.
Align the grooves in the clutch outer with the
bosses on the oil pump drive sprocket while turning
the sprocket with the chain and pushing the clutch
outer onto the shaft.
Apply molybdenum disulfide oil solution to the
thrust washer.
Install the thrust washer onto the mainshaft.
CLUTCH/GEARSHIFT LINKAGE
DRIVE SPROCKET
" " MARK
DRIVEN SPROCKET
BOLT
CLUTCH OUTER
THRUST WASHER
DRIVE CHAIN
Align
WASHER
Align
10-17